After looking online at this unit, it looks like the interface box is
not external, but fits in a 5.25 drive bay instead, with a ribbon cable
internally connecting that to the card inside. Ugly, very ugly way of
doing it. It appears to also be RCA's as connectors rather than balanced
From: Association for Recorded Sound Discussion List
[mailto:[log in to unmask]] On Behalf Of Richard L. Hess
Sent: Thursday, September 15, 2005 4:33 PM
To: [log in to unmask]
Subject: Re: [ARSCLIST] Reducing soundcard/circuit noise
Sounds close to a broken shield/ground between the card and the I/O box
- but that's a guess. If you move the box around while recording, what
At 01:59 AM 9/16/2005, you wrote:
>Dear Rod, Mike, Lou, Richard, Joe, etc.
>Thank you very much for your advice!
>I've disconnected the monitor and recorded "silence", but the buzz
>(like a shaver) was still present. I've removed the I/O box from the
>PC case and everything sounded much better. One thinks of upgrading
>one's system (in need of speed) just to encounter new problems slowing
>you down again!
Richard L. Hess email: [log in to unmask]
Media web: http://www.richardhess.com/tape/
Aurora, Ontario, Canada (905) 713 6733 1-877-TAPE-FIX
Detailed contact information: