OK...so am I understanding correctly that you are transferring through
your converter into your computer at 16bit, but then importing it into
ProTools for 24bit?
If this is the case, you're not "enhancing" the sound quality, but just
using some kind of algorithm(s) in order to get a more complex file -
information that was added, by the way, and has nothing to do with the
"If someone, holding fast to the name of Bodhisattva Perceiver of the
World's Sounds should enter a great fire, the fire could not burn
him...If one were washed away by a great flood and call upon his name,
one would immediately find himself in a shallow place." (The Lotus
On 20-Feb-06, at 10:08 PM, Lou Judson wrote:
> Interesting perspective. When I transfer cassettes for clients, I use
> 16 bit, and if they want it processed in any way, I import it to 24
> bit Protools sessions for the added range... Best of both worlds, I
> like to think.
> Lou Judson • Intuitive Audio
> On Feb 20, 2006, at 10:00 AM, Mike Richter wrote:
>> Lou Judson wrote:
>>> What about using 24 bit at 44.1 so that any noise reduction or
>>> processing done later is higher definition?
>> Given that the best dynamic range on standard cassettes - assuming
>> Dolby B in proper calibration which is highly questionable - is
>> unlikely to exceed 60 db, one might suspect that 16 bits is
>> sufficient. Of course, processing could consume several bits and one
>> only has half a dozen to spare (~30 db).
>> For that potential, infinitesimal advantage, one is likely to spend
>> four to ten times as much to make the transfers counting both
>> equipment and time. Given infinite resources, a case can be made;
>> with a budget less than that of a typical multinational corporation,
>> such overkill is hard to justify even on theoretical grounds.
>> [log in to unmask]