We're not talking about the same things at all.
My stack is very stable. Been OK for 5 years in its present form. Stuff gets taken out and put back
daily. No shake rattle or roll.
The setup at my parents house was indeed custom built, the point of the story being the extra
support columns for the floor.
So, no complaints anywhere here.
----- Original Message -----
From: "Roger and Allison Kulp" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Thursday, December 21, 2006 3:23 PM
Subject: Re: [ARSCLIST] Floor Load Capacity
> This arrangement your parents had sounds costly,and not one most people could afford.I think
> you're saying they had a custom-built room made ?
> If you and I are thinking of the same kind of crates,the wood is very thin and the boards split
> easily,when any weight is applied.They also tend to fall over,if they are stacked too high on
> their sides.
> Roger Kulp
> Tom Fine <[log in to unmask]> wrote: For what it's worth, when my parents moved into the
> house I grew up in, a few years before I was
> born, they decided to consolidate their very large collection of records and tapes -- at least
> not in my father's office at the studio. The basement was non-ideal because it's too wet and too
> dark/dank for my mother in any case. So they decided to put them all on a long wall, floor to
> ceiling, in their shared office room. The contractor planned out the shelves and then did weight
> estimates and promptly changed the plan so that first of all, the shelves were on a structural
> and second that there were new reinforcing columns added below. He did something where the weight
> centered on a foundation wall (stone and morter) because the wall is where the original house
> a late 1800's expansion (the office is the ground floor of the expansion). The shelves have been
> chock full -- I mean full to the brim -- of records and tapes since 1964 and no problems thus far.
> I'd estimate the weight must be approaching a ton, spread down a 15' or 20' length. The shelves
> hardwood, I think.
> In my house, I have a similar shelf, but it's free-standing on the carpeted concrete slab
> downstairs. I just stacked up a wall's worth of those pine cubes you can find at AC Moore and
> stores. AC Moore has a coupon in our pennysaver each week, so all were bought at 30 or 50 percent
> off sticker. There's another similar stack in the furnace room for my extensive collection of
> books and magazines.
> By the way, at 128K MP3, the entire wall at my parents' house could fit in an 80-gig iPod, half a
> deck of cards. The quality would not be anywhere near the original, though.
> -- Tom Fine
> ----- Original Message -----
> From: "Roger and Allison Kulp"
> Sent: Thursday, December 21, 2006 1:00 PM
> Subject: Re: [ARSCLIST] Floor Load Capacity
>>I never had to worry about that,as mine have always bee in a ground-level area, witha a concrete
>>floor.I would not suggest anybody store a big collection any other way.
>> Roger Kulp
>> Nicole Blain wrote: Hello all,
>> Does anyone know what the standards are for floor load capacity for stacks of 12" vinyl and 10"
>> shellac discs.
>> The standard for library book stacks is ~150 pounds psf. I tried and failed to find anything on
>> the internet that specifies vinyl and/or shellac. I imagine it would be higher for the latter.
>> If there's an official document or study out there too, it would help convince the
>> architects/engineers that this is an important issue.
>> I found an article in the Fall 1993 ARSC Journal: Storage of Sound Recordings by Richard Warren
>> Jr. He has weight per linear foot, but not floor load capacity.
>> Our collection houses ~175,000 12" vinyl and ~30,000 10" shellac discs.
>> Nicole Blain
>> Manager, Music Library/
>> Chef, Musicothèque
>> P.O. Box 500, Station A
>> Toronto, ON
>> Canada M5W 1E6
>> Tel: 416.205.5901
>> Fax: 416.205.8574
>> [log in to unmask]
>> Do You Yahoo!?
>> Tired of spam? Yahoo! Mail has the best spam protection around
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam protection around