Thanks for the tutorials, folks...
On 8/26/08 4:48 PM, "Richard L. Hess" <[log in to unmask]> wrote:
load, as seen by the cartridge.
> Hi, Andrew,
Hi, Mr. Hess,
> You don't want to double-terminate the cartridge.
Ok... I just thought that would get me a lot closer to Z = 47k, since the
combined Z would be what the cartridge actually "saw" (no?); the sum would
be about 50k Ohms, tops. What causes the difficulty? i.e., Why not "y-"?
> ... I forget the exact range of
> values for a moving magnet cartridge, but the resistance should be 47
> K ohms and the capacitance is around 100-200 pF. Cable is often 20-40
> pF per foot.
And here I thought that the capacitance (in the cabling, and entire network)
was merely something to try to minimize (due to the LPF effect of the R-C
If I were to use the 14 pF/foot Mogami 3080 cable, could I get to the target
loading value by merely making the interconnects 10 feet long? ]: (14 x 10
= 140 pF)
Or is it actually better (for other reasons than cap and Z, alone) to use
cabling which is as short as physically possible with a small tuning cap
hung off the ends?