Thanks for the thoughts on this guys. I've set the tape aside for now and
will look into trying out some of these remedies.
From: Association for Recorded Sound Discussion List
[mailto:[log in to unmask]] On Behalf Of Shai Drori
Sent: Tuesday, December 15, 2009 1:12 PM
To: [log in to unmask]
Subject: Re: [ARSCLIST] Tape Shed-Sticking & stripping
This reminds me of the "grandfather clock" thingamajig I saw at the
British library. It is a large board with rollers that the tape goes
through making a serpentine. The tape travels very slowly and can be
heated or chilled as needed. They made this for some agfa tapes that
stuck. I have never had a 3m 176 make trouble but this sounds like many
50's 60's tapes I transfered that were of American origin. One squealed
so bad we had to soak it with silicone. I am wondering it there is a
benefit to slow winding under a cold air blast, like an air conditioning
duct pointing at the transport. My a/c/ has a setting for drying the
air. Very cold air forced out and the rh drops very fast..
Richard L. Hess wrote:
> Hi, Martin,
> This is very problematic, and I do NOT think baking is a good idea.
> There is a CHANCE that month-long cold soak in a desiccated atmosphere
> (silica gel inside double freezer (or foil) Zip-Loc bags in the fridge
> (not freezer)).
> It has worked for some 3M 176 that showed this symptom. It has also
> not worked for other tapes. Jim Wheeler gave me this technique. I
> don't know his source. I haven't used it much.
> The other thing to try is VERY slow unwinding - 1.88 in/s or slower.
> Sometimes that alone helps.
> The tape in the photo was baked based on a consensus of the people at
> the seminar (including the tape owner) because we didn't have time for
> cold soak and we wanted to see what would work (or not).
> Since that article, I have had good results with 3M201 which had the
> same problem and the 1.88 in/s wind-through solved it.
> Good luck!
> At 12:34 PM 2009-12-15, Martin Fisher wrote:
>> Got a polyester/plastic non-backcoated reel in which the binder is
>> stripping off onto the adjacent wind. AKA "binder adhesion to back
>> of next layer" on Richard Hess' site.
>> Might baking be a solution for this?
> Richard L. Hess email: [log in to unmask]
> Aurora, Ontario, Canada (905) 713 6733 1-877-TAPE-FIX
> Detailed contact information: http://www.richardhess.com/tape/contact.htm
> Quality tape transfers -- even from hard-to-play tapes.
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.716 / Virus Database: 270.14.109/2567 - Release Date: 12/15/09