Thanks! I noticed there wasn't a "record" button. Strange operational  
quirk! Does it play back to? I noticed it has a speaker... Never  
mind, I'll read the reast of the "manual" such as it is!

<L>

On Dec 13, 2010, at 10:20 AM, Frank Strauss wrote:

On Mon, Dec 13, 2010 at 12:14 PM, Lou Judson <[log in to unmask]> wrote:

> Pardon if this is an absurd question, but is there a power switch  
> that you
> might not be turning off? I have an H2 and a Q3 and they turn off  
> completely
> when not in use... The manual says hold the power/hold button down  
> for 1
> second to turn off.
>
> Not at all an absurd question.  The unit has a switch that is to be  
> pulled
> down and held momentarily, to start it.  When this is done, a  
> message comes
> on the display that says "Hi", and then the display is populated  
> with info.
> When recording is complete, the same switch is pulled down, again held
> momentarily, and the words "Good Bye" come on the display, and the  
> display
> then goes blank.  The switch has a "Hold" position that can be  
> engaged so
> that the unit doesn't get turned on or off accidentally, and I do  
> put the
> switch in this position.  There are no indications that power is  
> being drawn
> after the display says "Good Bye"  I went to the Zoom website in  
> Japan, and
> they referred me to the US distributor, SamsonTech. I have sent an  
> email to
> the Zoom support department at SamsonTech, and they haven't gotten  
> back to
> me.
>
>

-- 
Frank B Strauss, DMD