3 solder connections under motor - look for 3 bad solder joints-Mickey
Follow me on Twitter
https://twitter.com/MickeyRClark
M.C.Productions Vintage Recordings
710 Westminster Ave. West
Penticton BC
V2A 1K8
1-250-462-7881
http://mcproductions.ca
----- Original Message -----
From: "David Glasser" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Tuesday, January 26, 2016 2:58 PM
Subject: Re: [ARSCLIST] Technics SP-10MkII repair
> Thank you Dave, and everyone else for the suggestions. Problem: Power
> supply voltages are all OK, voltages at the power supply header on the
> turntable PCB are correct. Speed selection will not latch, platter does't
> spin, strobe does not light. Speed selection LEDs glow dimly. Maybe that
> info will ring a bell.
>
> best,
>
> David Glasser
> Chief Engineer
> Airshow
> 3063 E Sterling Circle #3
> Boulder, CO 80301
>
> 303-247-9035
>
> [log in to unmask]
>
>
>
> On Jan 26, 2016, at 3:43 PM, Dave Cawley <[log in to unmask]> wrote:
>
>> From: Dave Cawley
>> Timestep Dartmouth
>> e-mail [log in to unmask]
>> Web site www.78-rpm.com
>> Tel: from USA : 011 44 1803 833366
>> Fax: from USA : 011 44 1803 839498
>>
>>
>> Exactly what is wrong with it ?
>>
>> Dave
>
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
|
