Hi, John, and Frank,
In reading the two paragraphs quoted below, there is some ambiguity that
the resurfacing machine might be used on the label side. That is not
possible, is it? I don't think on a single-layer CD that can be done.
Since I was confused slightly, I thought I'd mention it publicly in case
anyone else might be.
The confusion stems from Frank saying the PVC is only on the label side
and then John saying not to use it for removing large foreign objects
like a PVC layer.
On 12/9/2016 12:38, John Schroth wrote in part:
> Hi Frank:
> > I would not buy the resurfacing machine to remove large foreign objects
> such as a PVC layer from the disks. It could be used to resurface a disk
> that has had minor to major surface damage to the disk while removing
> the PVC layer from the disk. It can remove scratches that are
> surprisingly severe (unless they've gone straight through the protective
> layer) without damaging the disk. I've also seen a haze built up on
> disks over the years and the machine is great for general cleaning and
> removing haze.
> On 12/9/2016 12:02 PM, Frank Ferko wrote in part:
>> Hi, John,
>> Our sleeves have PVC on only one side with cloth on the other side, so
>> the side with printing is the only side that is sticking.
Richard L. Hess email: [log in to unmask]
Aurora, Ontario, Canada 647 479 2800
Quality tape transfers -- even from hard-to-play tapes.