LISTSERV mailing list manager LISTSERV 16.0

Help for ARSCLIST Archives


ARSCLIST Archives

ARSCLIST Archives


[email protected]


View:

Message:

[

First

|

Previous

|

Next

|

Last

]

By Topic:

[

First

|

Previous

|

Next

|

Last

]

By Author:

[

First

|

Previous

|

Next

|

Last

]

Font:

Proportional Font

LISTSERV Archives

LISTSERV Archives

ARSCLIST Home

ARSCLIST Home

ARSCLIST  October 2018

ARSCLIST October 2018

Subject:

Re: Soundmirror paper 1/4" tape

From:

"Richard L. Hess" <[log in to unmask]>

Reply-To:

Association for Recorded Sound Discussion List <[log in to unmask]>

Date:

Tue, 16 Oct 2018 20:08:09 -0400

Content-Type:

text/plain

Parts/Attachments:

Parts/Attachments

text/plain (173 lines)

Hi, Tim,

The only thought I had is that there was moisture intrusion into the 
tape pack at some point to cause this. This could have been moisture on 
its own or with biological or chemical contaminants that acted like an 
adhesive or caused the tape coatings to act like an adhesive.

It is just a guess with no real science to back it up.

Yes, I would try baking to separate, but that's not always useful, either.

The other thing that has occasionally worked with blocked tapes is 
chilling them for a while, both to drive out moisture and get some 
micro-movement layer to layer which may "unhook" the little bonds.

If you hear a zipper noise, you are damaging tape.

Good Luck!

Richard




On 2018-10-16 4:58 PM, Tim Gillett wrote:
> Hi Corey,
> 
> No, definitely not normal sticky shed or even any stickiness.
> 
> My tentative guess is that with time and pressure the rough surface of 
> the paper backing has imprinted itself onto the adjacent layer's 
> smoother oxide surface so that   many tiny "interlock" or clasp points 
> have formed. On the sections where the winds have separated without 
> damage, the interlocks have released and now there is no longer a 
> stiction in those sections. I can rewind the tape back from where the 
> tape stopped and it winds perfectly.  No stiction. For a paper tape, the 
> pack is quite good. When I run the tape forward, as soon as it gets to 
> the point where I stopped separating the wind, the adhesion resumes.
> 
> It's complicated by  various sticky tape splices which have gone gooey 
> and oozed, causing adhesions at those points but that's a separate issue.
> 
> Yes there are unrecorded sections which I can experiment with.
> 
> Thanks,
> Tim
> 
> 
> ----- Original Message ----- From: "Corey Bailey" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Wednesday, October 17, 2018 4:12 AM
> Subject: Re: [ARSCLIST] Soundmirror paper 1/4" tape
> 
> 
>> Hi Tim,
>>
>> It's hard to recommend a solution without visually assessing the 
>> problem. For polyester base tapes that have layer-to-layer adhesion, I 
>> usually have to bake them at a lowered temperature (118° F. or less) 
>> for 6 to 8 hours and then I will check the tape again. For paper 
>> backed tape, baking may not work. Is there an unrecorded section that 
>> you could use for testing? For me, baking audio tape is reserved as a 
>> last resort. Layer-to-layer adhesion is the one exception.
>>
>> Cheers!
>>
>> Corey
>>
>> Corey Bailey Audio Engineering
>> www.baileyzone.net
>>
>> On 10/16/2018 6:11 AM, Tim Gillett wrote:
>>> Thanks Gary,
>>>
>>> Yes having had experience with one tape like this 15 years ago (from 
>>> the same person's archive) I'm aware of the centre track, the tracks 
>>> 2 and 3 capture and the azimuth corrector technique. It's just a 
>>> shame I wasnt aware of this sticking problem back then as I guess if 
>>> I'd unwound them then it wouldnt have been as much of a problem as 
>>> has now become 15 years on.
>>>
>>> I only recently discovered that the tapes have been stored in less 
>>> than ideal conditions with high humidity and evidence of mould on 
>>> some tapes (but apparently not on any of these Soundmirror tapes that 
>>> I can see.
>>>
>>> Yes hoping Richard Hess or maybe Peter Brothers might have experience 
>>> with this sticky problem.
>>>
>>> Regards,
>>>
>>> Tim.
>>>
>>>
>>> ----- Original Message ----- From: "Gary A. Galo" <[log in to unmask]>
>>> To: <[log in to unmask]>
>>> Sent: Tuesday, October 16, 2018 8:57 PM
>>> Subject: Re: [ARSCLIST] Soundmirror paper 1/4" tape
>>>
>>>
>>> Hi Tim,
>>>
>>> This is a strange problem. I've worked with quite a few Brush 
>>> Soundmirror tapes in our archive, and the only spots where I found 
>>> any sticking was on a couple that had leader tape spliced on at the 
>>> beginning. But, it was confined to that spot, and not all the way 
>>> through.
>>>
>>> Regarding playback on modern equipment, I use tracks 2 and 3 of a 
>>> 4-channel head. They fit right over that single half track on the 
>>> Soundmirror tapes. The stereo playback allows proper azimuth 
>>> adjustment, and gets you inside of most of the edge curl that may 
>>> have occurred. It may also get you inside any oxide shedding that may 
>>> happen, if that stickiness is confined to the edges. Then I put the 
>>> two channels through a phase corrector before summing them to mono.
>>>
>>> Richard Hess may be able to better address the sticking problem.
>>>
>>> Best
>>> Gary
>>>
>>> Gary Galo
>>> Audio Engineer Emeritus
>>> The Crane School of Music
>>> SUNY at Potsdam, NY 13676
>>>
>>> ________________________________
>>> From: Association for Recorded Sound Discussion List 
>>> <[log in to unmask]> on behalf of Tim Gillett 
>>> <[log in to unmask]>
>>> Sent: Tuesday, October 16, 2018 8:32:39 AM
>>> To: [log in to unmask]
>>> Subject: [ARSCLIST] Soundmirror paper 1/4" tape
>>>
>>> Hello,
>>>
>>> I'm having problems with some very early Soundmirror tapes using a 
>>> paper backing, circa late 40's early fifties I guess. I suspect they 
>>> havent been wound or played for many decades. They contain live 
>>> recordings of mainly classical oratorio concerts.
>>>
>>> The tape wind is semi sticking to the next wind in varying degrees 
>>> depending on the tape in question. With a couple I've been able to 
>>> slowly wind them off without tape breakage or loss of oxide. Once 
>>> they have been unstuck and spooled onto the take up reel they remain 
>>> unstuck and play well. I've been able to repair old splices and clean 
>>> off old spreading adhesive.
>>>
>>> But this one is more sticky and further into the reel I go it has 
>>> started to really stick to the next wind and rip off small pieces of 
>>> oxide (I guess more tension from being under a constant torque wind 
>>> for many years has made the inner layers stick more to each other).
>>>
>>> Any hints on treating the tape to help it wind off without damage, or 
>>> with less damage? Heat, humidity etc?
>>>
>>> Thanks,
>>>
>>> Tim Gillett
>>> Perth,
>>> Western Australia 
> 
> 
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
> 
-- 
Richard L. Hess                   email: [log in to unmask]
Aurora, Ontario, Canada                             647 479 2800
http://www.richardhess.com/tape/contact.htm
Quality tape transfers -- even from hard-to-play tapes.

Top of Message | Previous Page | Permalink

Advanced Options


Options

Log In

Log In

Get Password

Get Password


Search Archives

Search Archives


Subscribe or Unsubscribe

Subscribe or Unsubscribe


Archives

March 2024
February 2024
January 2024
December 2023
November 2023
October 2023
September 2023
August 2023
July 2023
June 2023
May 2023
April 2023
March 2023
February 2023
January 2023
December 2022
November 2022
October 2022
September 2022
August 2022
July 2022
June 2022
May 2022
April 2022
March 2022
February 2022
January 2022
December 2021
November 2021
October 2021
September 2021
August 2021
July 2021
June 2021
May 2021
April 2021
March 2021
February 2021
January 2021
December 2020
November 2020
October 2020
September 2020
August 2020
July 2020
June 2020
May 2020
April 2020
March 2020
February 2020
January 2020
December 2019
November 2019
October 2019
September 2019
August 2019
July 2019
June 2019
May 2019
April 2019
March 2019
February 2019
January 2019
December 2018
November 2018
October 2018
September 2018
August 2018
July 2018
June 2018
May 2018
April 2018
March 2018
February 2018
January 2018
December 2017
November 2017
October 2017
September 2017
August 2017
July 2017
June 2017
May 2017
April 2017
March 2017
February 2017
January 2017
December 2016
November 2016
October 2016
September 2016
August 2016
July 2016
June 2016
May 2016
April 2016
March 2016
February 2016
January 2016
December 2015
November 2015
October 2015
September 2015
August 2015
July 2015
June 2015
May 2015
April 2015
March 2015
February 2015
January 2015
December 2014
November 2014
October 2014
September 2014
August 2014
July 2014
June 2014
May 2014
April 2014
March 2014
February 2014
January 2014
December 2013
November 2013
October 2013
September 2013
August 2013
July 2013
June 2013
May 2013
April 2013
March 2013
February 2013
January 2013
December 2012
November 2012
October 2012
September 2012
August 2012
July 2012
June 2012
May 2012
April 2012
March 2012
February 2012
January 2012
December 2011
November 2011
October 2011
September 2011
August 2011
July 2011
June 2011
May 2011
April 2011
March 2011
February 2011
January 2011
December 2010
November 2010
October 2010
September 2010
August 2010
July 2010
June 2010
May 2010
April 2010
March 2010
February 2010
January 2010
December 2009
November 2009
October 2009
September 2009
August 2009
July 2009
June 2009
May 2009
April 2009
March 2009
February 2009
January 2009
December 2008
November 2008
October 2008
September 2008
August 2008
July 2008
June 2008
May 2008
April 2008
March 2008
February 2008
January 2008
December 2007
November 2007
October 2007
September 2007
August 2007
July 2007
June 2007
May 2007
April 2007
March 2007
February 2007
January 2007
December 2006
November 2006
October 2006
September 2006
August 2006
July 2006
June 2006
May 2006
April 2006
March 2006
February 2006
January 2006
December 2005
November 2005
October 2005
September 2005
August 2005
July 2005
June 2005
May 2005
April 2005
March 2005
February 2005
January 2005
December 2004
November 2004
October 2004
September 2004
August 2004
July 2004
June 2004
May 2004
April 2004
March 2004
February 2004
January 2004
December 2003
November 2003
October 2003
September 2003
August 2003
July 2003
June 2003
May 2003
April 2003
March 2003
February 2003
January 2003

ATOM RSS1 RSS2



LISTSERV.LOC.GOV

CataList Email List Search Powered by the LISTSERV Email List Manager