Hi Charles, Have you tried the suggestions around summing to mono? It
can work quite well, with few or no artifacts.
Tim.
----- Original Message -----
From: "Association for Recorded Sound Discussion List"
<[log in to unmask]>
To:<[log in to unmask]>
Cc:
Sent:Sun, 13 Sep 2020 17:25:30 -0700
Subject:Re: [ARSCLIST] Izotope RX8; recordings of FM broadcasts with
multipath distortion
Richard and Lou,
Thank you very much for the ideas. You've given me back some hope
for
these tapes. I was using RX7 spectral de-noise, but it was leaving
too
much residual noise, and I couldn't push it further without losing
content and creating artifacts. It seems I need to be a bit more
adventuresome in my experimentation.
I have RX7 advanced, so the upgrade cost to 8 advanced is not too
terrible
Will let you know if I am successful using what you have suggested.
chuck
find some non-destructive ways of
On 9/13/2020 1:48 PM, Richard L. Hess wrote:
> Hi, Lou,
>
> That is a good suggestion, but we already have an M-S thing going
on
> as I explained in a previous email. All the noise is in the L-R
> channel which, unfortunately was mixed back into the quiet L+R
channel
> when the stereo was demodulated in the tuner to make the tape
> recording. So, the act of summing L + R from the tape will act to
> cancel out the noise, but the balance between L + R will need to be
> tuned for minimum noise, as you know when you're trying to null
> things, 1-2 dB in level makes a big difference.
>
> I haven't thought what subsequent M-S processing might do, but that
> would put it back into L+R and L-R and might be another way of
looking
> at the same thing...just attenuating the S channel would work the
same
> as summing, but the match is critical in either case.
>
> Cheers,
>
> Richard
>
>
>
> On 2020-09-13 4:35 p.m., Lou Judson wrote:
>> I wonder if an MS treament would help with multipath - EQ the side
>> signal to reduce noise, bost the mid to compensate, then
recombine. I
>> don;t have a sample to try this on but it has worked for me for
>> stereo noise in the past.
>>
>> <L>
>> Lou Judson
>> Intuitive Audio
>> 415-883-2689
>>
>>> On Sep 13, 2020, at 1:16 PM, Lou Judson <[log in to unmask]>
wrote:
>>>
>>> FM multipath? Good question. Have you tried it in mono? Mono-ing
the
>>> receiver cleans it right up, but I don’t now about after it is
>>> recorded.
>
--
Charles Reinsch
KRAB Archive: www.krabarchive.com
-------------------------
Email sent using Optus Webmail
|