From: Association for Recorded Sound Discussion List <[log in to unmask]> On Behalf Of Richard L. Hess
Sent: Tuesday, April 27, 2021 4:12 PM
To: [log in to unmask]
Subject: Re: [ARSCLIST] [EXTERNAL] Re: [ARSCLIST] iZotope RX7 quesiton
I was going to suggest that as well. But I'll throw in Samplitude (and presumably Sequoia) have a "Remove DC Offset" under Restoration. It is a "destructive" "off-line" effect which writes to the file, rather than adjusting it virtually as almost everything else does in Samplitude/Sequoia.
I just checked a file that I ingested yesterday, no DC offset, but I understand your need.
On 2021-04-27 3:50 p.m., Gary A. Galo wrote:
> Thanks, Joe. There is a way to set the notch to 0 dB - it works.
> Nice to hear from you. I hope you are doing well.
> -----Original Message-----
> From: Association for Recorded Sound Discussion List
> <[log in to unmask]> On Behalf Of Joe Salerno
> Sent: Tuesday, April 27, 2021 12:57 PM
> To: [log in to unmask]
> Subject: Re: [ARSCLIST] [EXTERNAL] Re: [ARSCLIST] iZotope RX7 quesiton
> Hi Gary,
> Perhaps as a workaround, could you give RX an "empty" hum print? In other words, a hum print that is silent?
> I used to use a video editing program that had to be fooled sometimes by placing an empty filter on a clip and making it render while making no change in that clip. It was called a forced render.
> Joe Salerno
Richard L. Hess email: [log in to unmask]
Aurora, Ontario, Canada 647 479 2800
Track Format - Speed - Equalization - Azimuth - Noise Reduction Quality tape transfers -- even from hard-to-play tapes.