Print

Print


With permission from Stan Ricker:
----- Original Message ----- 
From: "Stan Ricker"

Ya--------part of the cutter-amp circuitry; in a plug-in card, in the 
Neumann case, the amount of "pre-distort" is diameter-dependent, triggered 
by many microswitches along the sled-path.......just before the RIAA eq...

> phillip holmes wrote:
>> So the Dynagroove process was at the mastering end of things (between the 
>> tape deck and the cutter head)?
----- Original Message ----- 
From: "Stan Ricker"
To: "phillip holmes"


>>> NEUMANN CALLED THIS "PREDISTORT" CIRCUIT" A "TRACING SIMULATOR"----AND
>>> NOBODY LIKED IT EITHER.........THE TELDEC SYSTEM MENTIONED BELOW IS THE 
>>> NEUMANN SYSTEM..............THANK GOODNESS "DYNAGROOVE" WAS ONLY 
>>> MASTERING,
>>> AND NOT ORIGINAL RECORDING AS WELL...........STAN
>>>
>>> phillip holmes wrote:
>>>
>>>> Do you know if the pre-distortion on the Dynagroove pressings were on 
>>>> the tapes or done by the mastering engineers?  Enquiring minds want to 
>>>> know.
>>>> Phillip