Print

Print


DC6 and DC7 have a variety of phono-EQ built in as pre-sets for the DSP EQ.

I'm a very big fan of doing phono EQ in the analog domain. Sorry, I just don't trust DSP enough. I 
can say for sure that I much prefer my phono preamp (made by Audio Design Associates, and I also 
prefer my homebrew Marantz 7 phono stage) to the DC6 DSP and also a hand-made EQ curve in 
SoundForge. Given all the talk we've had about bit-mangling in just the recording phase, do you 
really trust most DSP for a radical EQ like a compensation curve? If you're getting good results 
with digital, bully for you, but I recommend you try a good preamplifier matched properly to your 
cartridge and then LISTEN to the two versions and see which you really like better.

One man's opinions, etc.

-- Tom Fine

----- Original Message ----- 
From: "Bob Olhsson" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, August 25, 2008 1:13 AM
Subject: Re: [ARSCLIST] RIAA EQ software


>I know of nothing free however the de-emphasis presets that Michael Gerzon
> created as part of the WAVES Q-10 equalizer plug-in are extremely accurate.
>
> Bob Olhsson Audio Mastery, Nashville TN
> Mastering, Audio for Picture, Mix Evaluation and Quality Control
> Over 40 years making people sound better than they ever imagined!
> 615.385.8051 http://www.hyperback.com    http://www.thewombforums.com
>
>
> -----Original Message-----
> From: Association for Recorded Sound Discussion List
> [mailto:[log in to unmask]] On Behalf Of Scott Phillips
> Sent: Sunday, August 24, 2008 10:56 PM
> To: [log in to unmask]
> Subject: [ARSCLIST] RIAA EQ software
>
> Does anyone have any suggestions for software to apply the RIAA EQ curve
> to a file from a disk transfer ? I have Soundforge 9, and figure I could
> dial up the approximate curve, but is there anything specific out there
> ? Free is always nice, but not a requirement.
>
> Scott Phillips
>