Print

Print


No probs, Rod. You're more than welcome. I learn a lot from the ARSC List, so I enjoy spreading some 
old knowledge. It's kind of a recycling exercise.

Does anyone know if there is software that does the following: if I un-stapled magazines that are 
made of 11x17 folded sheets, and ran those sheets through the scanner, scanning both sides, is there 
software that will then break the scans into 8.5x11 pages and put them in the proper order into a 
PDF document?

-- Tom Fine

----- Original Message ----- 
From: "Roderic G Stephens" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Thursday, April 26, 2012 3:34 PM
Subject: Re: [ARSCLIST] the birth of the ATR-100, tape-path tension, tape editing from the aces at 
CBS Radio, etc


Thanks, Tom for taking the time to share with us your excellent articles. It takes time to scan 
these, so again thank you for using your personal time.

--- On Thu, 4/26/12, Tom Fine <[log in to unmask]> wrote:

From: Tom Fine <[log in to unmask]>
Subject: [ARSCLIST] the birth of the ATR-100, tape-path tension, tape editing from the aces at CBS 
Radio, etc
To: [log in to unmask]
Date: Thursday, April 26, 2012, 11:42 AM

http://www.yousendit.com/download/M3BsZGlwMHc3N0JvSWNUQw?cid=tx-02002207340200000000&s=19102
(remember to paste complete link into your browser)

Some scans from dB Magazine, including a 2-parter on the development of the Ampex ATR-100, and a 
primer on tape editing tricks from one of the old-school aces at CBS Radio.

Note that the Ampex 350/Lang editing carts shown in the CBS Radio photos ended up being part of one 
of the best dumpster dives in NYC history, when CBS dumped them all in the early 90's. I don't know 
this for a fact, but I suspect Lang developed those editing carts for CBS Radio and then sold them 
to others. They were shown in Lang literature from the mid-60's. The carts contained a JBL or Jensen 
full-range speaker in the door, powered by a Langevin 10W tube amplifier. I think some of the carts 
had Lang electronics inside, some used Ampex 351 electronics with the VU meter and some controls 
moved up to the panel behind the transport. The units I saw from the dumpster dive were in very 
rough shape, but the Langevin power amps, full-range speakers and parts from the tape electronics 
made for good eBay fodder. The rollarounds are rock-solid. I still have one.

Also of interest is the followup to the CBS Radio article, from a former audio man there. The story 
of Joel Tall inventing the editing block is recounted. I have previously posted a scan of the liner 
notes of the original 12" 78 multi-disk album of Edward R. Murrow's first "I Can Hear It Now," which 
discussed using the great "new" medium of magnetic tape to produce the recording, with Joel Tall 
being one of the mentioned editors. Joel Tall of course patented, developed and sold the EdiTall 
splicing block.

As for the cover photo (the single JPG file), here's the caption (obviously meant somewhat tongue in 
cheek):
"Chief Engineer Kurt Munkacsi of New York's Big Apple Recording Studio must sometimes resort to 
extremely drastic means to adjust torque on his machines. He can be seen in more normal pose on the 
cover of John Woram's "The Recording Studio Handbook." Photo is by Ray Buchner."

-- Tom Fine