Thanks, Richard! Best, Gary -----Original Message----- From: Association for Recorded Sound Discussion List <[log in to unmask]> On Behalf Of Richard L. Hess Sent: Tuesday, April 27, 2021 4:12 PM To: [log in to unmask] Subject: Re: [ARSCLIST] [EXTERNAL] Re: [ARSCLIST] iZotope RX7 quesiton Hi, Gary, I was going to suggest that as well. But I'll throw in Samplitude (and presumably Sequoia) have a "Remove DC Offset" under Restoration. It is a "destructive" "off-line" effect which writes to the file, rather than adjusting it virtually as almost everything else does in Samplitude/Sequoia. I just checked a file that I ingested yesterday, no DC offset, but I understand your need. Cheers, Richard On 2021-04-27 3:50 p.m., Gary A. Galo wrote: > Thanks, Joe. There is a way to set the notch to 0 dB - it works. > > Nice to hear from you. I hope you are doing well. > > Best, > Gary > > > -----Original Message----- > From: Association for Recorded Sound Discussion List > <[log in to unmask]> On Behalf Of Joe Salerno > Sent: Tuesday, April 27, 2021 12:57 PM > To: [log in to unmask] > Subject: Re: [ARSCLIST] [EXTERNAL] Re: [ARSCLIST] iZotope RX7 quesiton > > Hi Gary, > > Perhaps as a workaround, could you give RX an "empty" hum print? In other words, a hum print that is silent? > > I used to use a video editing program that had to be fooled sometimes by placing an empty filter on a clip and making it render while making no change in that clip. It was called a forced render. > > Joe Salerno -- Richard L. Hess email: [log in to unmask] Aurora, Ontario, Canada 647 479 2800 http://www.richardhess.com/tape/contact.htm Track Format - Speed - Equalization - Azimuth - Noise Reduction Quality tape transfers -- even from hard-to-play tapes.